Compaq Storageworks HSJ80 Removing And Installing

R
EMOVING AND
I
NSTALLING AN
HSJ80 A
C
ONTROLLER
European Union Notice
Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and
the Low Voltage Directive (73/23 EEC) issued by the Commission of the European
Community. Compliance with these directives implies conformity to the following
European Norms (in brackets are the equivalent international standards):
EN 55022 (CISPR 22) Electromagnetic Interference
EN 50082-1 (IEC 801-2, IEC 801-3, IEC 801-4) Electromagnetic Immunity
EN 60950 (IEC 950) Product Safety
NOTICE
The information in this document is subject to change without notice. COMPAQ
COMPUTER CORPORATION SHALL NOT BE LIABLE FOR TECHNICAL OR EDITORIAL
ERRORS OR OMISSIONS CONTAINED HEREIN, NOR FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR
USE OF THIS MATERIAL. THIS INFORMATION IS PROVIDED "AS IS" AND COMPAQ
COMPUTER CORPORATION DISCLAIMS ANY WARRANTIES, EXPRESS, IMPLIED, OR
STATUTORY AND EXPRESSLY DISCLAIMS THE IMPLIED WARRANTIES OF
MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, GOOD TITLE AND AGAINST
INFRINGEMENT.
This publication contains information protected by copyright. No part of this
publication may be photocopied or reproduced in any form without prior written
consent from Compaq Computer Corporation.
©1999 Digital Equipment Corporation.
All rights reserved. Printed in the U.S.A.
Compaq, Compaq StorageWorks wordmark, StorageWorks
Registered in the U.S. Patent and Trademark Office and other jurisdictions.
Windows NT is a registered trademark of Microsoft Corporation.
INSTALLING AN HSJ80 ARRAY CONTROLLER
First Edition (December 1999)
Part Number 163139–001
EK–HSJAM–IA. A01
Compaq Computer Corporation
RRAY
About This Card
Follow these instructions to replace an HSJ80 ACS Version 8.5J
Array Controller. See the Compaq StorageWorks HSJ80 Array
Controller ACS V8.5J Maintenance and Service Guide for instructions
on upgrading a single-controller configuration to a dual-redundant
controller configuration.
General Information
Figure 1, Figure 2, and Figure 3 provide general information about the
serial maintenance connections and host cable connections for the
HSJ80 Array Controller.
3
4
5
1
PC to serial maintenance port cable
2
Serial maintenance port
3
Serial terminal to serial maintenance port cable (BC16E-xx)
4
Ferrite bead
5
RJ-11 adapter
6
RJ-11 extension cable
7
PC serial port adapter, 9 pin D-sub to 25 pin D-sub
Figure 1. HSJ80 array controller
1
2
6
7
CXO7003A