Install The Printhead - Canon imagePROGRAF iPF650 Install Manual

Install the Printhead

1
Open Upper Cover is shown on the
display screen. As instructed, open the top
cover .
a
Instructions on printhead replacement are
shown on the display screen.
3
Lift the printhead fi xer cover to open it
fully.
6 Insert the printhead into the carriage (b)
with the ink holes (a) facing away from the
printer as shown in the fi gure. Carefully
push the printhead fi rmly into the carriage
(b), ensuring that the part covered by
the protective part does not touch the
carriage.
b
9
Close the top cover .
Next, install the printhead.
• When installing the printhead, do not
move the carriage (a) from the position
shown in the fi gure.
If you move the carriage (a), a warning
noise sounds and the printhead cannot
be installed.
If you have moved the carriage (a),
close the top cover. The carriage (a)
moves to the position shown in the
fi gure.
4
Hold the printhead by the grips (a) as you
remove it from the pouch.
7
Pull the printhead fi xer cover down toward
the front to lock the printhead in place.
a
2
5
a
a
8
4
Pull the printhead fi xer lever forward all
the way to open it completely.
Remove the orange protective part (a).
To remove orange protective part (b),
push the grip (c) as you remove the
c
b
a
• Never touch the parts covered by the
protective part. This may damage the
printhead and affect printing quality.
• The printhead contains ink, so be careful
not to spill it once the protective part is
removed.
• Do not reattach the protective part after
removing it. Dispose of these materials
according to local regulations.
Push the printhead fi xer lever all the way
back.
part .