An Error Message Appears On The Screen - Canon i550 Quick Start Manual

Troubleshooting

An Error Message Appears on the Screen

Problem Possible Cause
Printer not ready
Error Writing /
Output to LPT1 or
USBxxx
Paper is not
loaded.
Faulty connection
Printer driver does
not installed
properly.
Not enough
memory
"Error No.: X202"
Printer driver fault
"Error No.: X203"
Printer not ready
"Error No.: X300"
Printer not properly
connected
Printer not selected
in chooser
46
The power lamp will flash green when the printer is warming up or when a print
job is being sent to the printer. It will glow a steady(non-flashing)green when it
is ready for use or when the print job is completed.
Load paper and press the RESUME/CANCEL
Ensure the printer cable is securely connected to the computer.
Note If you are using switching hub or other device, disconnect the
printer and reconnect it directly to the computer and try
printing again.
If successful, there may be a fault in the device.
There could also be a problem with the cable(s). Replace the
cable(s) and try printing again.
Uninstall then reinstall the printer driver.
1. Click Start Start, select All Programs All Programs (or Programs
Start Start All Programs All Programs
2. Follow the on-screen instructions to uninstall driver.
Follow the procedures described in the
the printer driver.
Not enough memory for printing. Increase available memory by closing any
other applications currently running.
There is a problem with the printer driver. Uninstall, then reinstall printer driver.
User's Guide for instructions on how to uninstall the printer driver.
Refer to the
If the POWER lamp is off, turn the printer on.
If the POWER lamp is flashing green, the printer is initializing. Wait until the
POWER lamp stops flashing.
Ensure the printer is securely connected to the computer.
Note If you are using switching hub or other device, disconnect
the printer and reconnect it directly to the computer and try
printing again.
If successful, there may be a fault in the device.
There could also be a problem with the cable(s). Replace the
cable(s) and try printing again.
1. From the Apple Apple menu, select Chooser Apple Apple
2. Click the i550 i550 icon and ensure i550 is selected as the target connection.
i550 i550
If not, select it.
Note If the problem persists, delete all unnecessary documents
from the Extensions and Control Panels folder.
Try This
RESUME/CANCEL button.
RESUME/CANCEL RESUME/CANCEL
Programs), Canon Canon i550
Programs Programs Canon Canon
Easy Setup Instructions and reinstall
Chooser. Chooser Chooser
i550, and Uninstall Uninstall.
i550 i550 Uninstall Uninstall