Getting Started; Operation; Diagnostic Checklist - Fedders TRION Installation Operation & Maintenance

High efficiency console electronic air purifier
Table of Contents

Advertisement

Available languages

Available languages

Getting Started

Install the charcoal filter
Remove the Charcoal Filter included with the air purifier
from the sealed plastic bag. To install the Charcoal Filter,
remove the Filter Access Cover by lifting upward. Lower the
Charcoal Filter into the filter rails located on the rear of the
Electronic Filter with the white side of the charcoal filter
facing the electronic filter. Replace the Filter Access Cover.
Location
This Air Purifier can be used in any room in the house or in
any workspace as long as air can freely circulate into the
upper grille and out through the lower grille. The unit
should never be placed near computers, radios, or TVs or
near sources of heat (such as stovetops and ovens).
Plug the unit in
Plug the unit into a polarized household electrical outlet.
Your air cleaner is now ready for operation.
Filter
Access
Cover
Filter
Assembly
Install the Charcoal
Filter on this side of
the Filter Assembly,
with the white side
facing the electronic
filter and the blue
side facing out.
2

Operation

Power the unit by pressing the On/Off button and then
press the button corresponding to the desired speed. Your
Electronic Air Purifier is designed for continuous operation
which also provides maximum efficiency in removing
airborne polutants.
Electronic Air Cleaner
WARNING
DO NOT USE THIS ELECTRONIC AIR CLEANER
WHEN OXYGEN IS BEING USED OR WHEN
COMBUSTIBLE GASES ARE PRESENT.

Diagnostic Checklist

Should you ever have any questions or concerns about the
operation of your Air Cleaning System, the chart below lists
potential problems and solutions.
Condition
Checkpoints
Unit fails to turn on
Make sure the power cord is
plugged in.
Set the On/Off switch to On
Set the fan to the desired speed.
Make sure the Filter Access Cover is
properly installed.
Make sure the Electronic Filter is
properly installed.
Unit does not
Wash the Electronic Filter.
remove pollutants
Unit snaps (arcs,
Wash the Electronic Filter and dry
crackles and pops)
thoroughly. Occasional snapping or
arcing sound is normal.
Prolonged or continuous arcing
is an indication that the filter has been
damaged and you should consult a
customer service representative.
Interference with
Move unit to a different location away
Radio and TV
from TV or Radio.
Clean the Electronic Filter if dirty.
Unit does not
Have unit serviced.
operate properly

Advertisement

Table of Contents
loading

Table of Contents