Canon BJC-S820D Quick Start Manual page 83

Troubleshooting
Error
Number
401
402
611/612
802, 803,
809
—
76
Problem
Front cover Close the front cover to start printing.
is open
Printhead is Attach the printhead. If the printhead is attached, remove the
not attached printhead, make sure that the contact sections are clean, and then
reattach the printhead.
Time Out is Remove the connected cable to reset the error. Reconnect the cable to
activated during the digital camera, and then start printing. For instructions on printing
communication from a digital camera, see the user's guide that comes with the digital
with the digital camera.
camera.
OR
A message, to the
effect that the
main unit does
not support the
digital camera,
is sent
Error occurred Press the Cancel button to stop printing, turn off the printer, wait
in printer awhile, and then turn on the power again. If the condition does not
improve, contact the store where you bought the printer or a nearby
repair center.
Photo cannot be Properly set a memory card that can be used. See "Using a Memory
read from Card" on page 28.
memory card
If a memory card is already set, eject the card, set it again, and check
(indicator lamp
that the indicator lamp goes on.
does not go on)
If the error is not corrected by the above procedure, turn off the printer,
unplug the power cord, and then turn on the power again.
Try This