Manual Setting - Canon imageCLASS MF6595 Starter Manual

Software Settings with Computer
The LCD display turned off:
●
The machine may enter the sleep mode while you are
setting up the machine. Press [POWER] to turn the
machine back on and continue the setup.
1
Press [Additional Functions].
2
Press [ ] or [ ] to select <9. SYSTEM
SETTINGS>, then press [OK].
3
Press [ ] or [ ] to select <2. NETWORK
SETTINGS>, then press [OK].
4
Press [ ] or [ ] to select <5. VIEW IP
ADDRESS>, then press [OK].

Manual Setting

This is the setting for the Static IP. If the machine gets IP address automatically in "Automatic Setting", skip
this setting.
In this setting, you enter the IP address, subnet mask, and gateway address manually. [Additional
Functions] → <9. SYSTEM SETTINGS> → <2. NETWORK SETTINGS> → <1. TCP/IP SETTINGS> → <1. IP
ADDRESS AUTO.> → <OFF> → <2. IP ADDRESS> → Enter the IP address → <3. SUBNET MASK> → Enter the
subnet mask → <4. GATEWAY ADDRESS> → Enter the gateway address number → Press [Stop] → Turn off
the main power → Restart the machine. For details on this setting, see Chapter 6, "Network (MF6595cx/
MF6595/MF6590/MF6540 Only), " in the Reference Guide. Once you complete the setting, please proceed
to "Checking the IP Address Setting, " on p. 19.
20
5
Press [ ] or [ ] to select <1. IP ADDRESS>,
<2. SUBNET MASK>, or <3. GATEWAY
ADDRESS>, then press [OK].
If the machine is communicated with the network
properly, the IP address, subnet mask and gateway address
are displayed.
If not, IP address, subnet mask and gateway address are
not displayed.
If the machine does not get the IP address 30 seconds after
you connect the LAN cable, turn off the main power switch
once, and then turn it on again and wait for another 90
seconds. If the machine still does not get the IP address,
ask your network administrator.
We recommend you to take a note of the IP address you
confirmed here, because you need it for Chapter 7, "Using
the Remote UI (MF6595cx/MF6595/MF6590/MF6540 Only), "
in the Reference Guide.
6
Press [Stop] to return to the standby mode.