Canon Powershot S10 Software Starter Manual page 60

Serial Interface
Select the port and baud rate settings, and click the [Set] button.
• Select the port to which the camera is attached.
• There is usually no need to change the baud rate setting from 115.2 K, but
if you are having trouble with the connection, try a slower baud rate.
What to Do if the [PowerShot Browser not found] Dialog Appears
If you install only the PowerShot Plug-
In Module without PowerShot
Browser, the [PowerShot Browser not
found] dialog may display. If this
happens, use the following procedures to prevent PowerShot Browser from
attempting to start automatically.
1) Click the [OK] button on the [PowerShot Browser not found] dialog.
2) In the [Settings for USB connection] dialog, click the [The application program
below will start.] option to clear the check mark.
3) Close the [Settings for USB connection] dialog.
This will prevent the [PowerShot Browser not found] dialog from appearing again
when the camera is connected.
* The [Settings for USB connection] dialog can also be opened by choosing the
(Apple) menu and selecting [Control Panels] and [Canon USB Camera]. (
Click here to close the dialog.
Click here to clear the check mark.
56
p. 46)