Advertisement
L5-STUDIO USER MANUAL - EN
USB: The USB 2.0 audio I/O connector
supporting the following:
1. Ability to simultaneously record the
RAW untreated sound to channel 1 (left)
and the full amplifier sound to the
channel 2 (right).
2. Ability to play back USB stereo
information to headphones for
monitoring.
Tip: Link from the Headphone output
back into the Auxiliary input with a
3.5mm to 6.5mm stereo jack lead
allowing simultaneous USB play back.
Tip: This feature will also allow external DSP effects on your DAW to use the RAW signal
as a left input then the effected signal sent directly back to the Aux input for mixing with the
amp "through" signal all via USB and without affecting your direct sound.
3. Re-Amp Send socket allows for the recorded RAW channel to be sent back to the
amplifier input for re-processing via a standard mono instrument jack lead. For the best
level match, use the HI input on the amplifier front panel. To fine tune the level, use the Dry
Recording Gain control. A good starting position for unity gain is the12 o'clock position.
High output pickups or lots of gain produced by FX pedals before the amp may require a
slight reduction in level via the Dry Recording Gain Level control to prevent overloading of
the input stage in your DAW.
Record out via USB: To run into iPad or iPad mini connect via a Camera USB adaptor,
PC/MAC connects via standard A-B USB cable, for use with the likes of Garage Band ®,
Audacity ®, MixPad Audio Mixer ®, Pro Tools and similar. It should be noted that the audio
output of an iPad or iPad mini is disengaged and returned via the USB. This can be picked
up via a rear panel monitor switch on the amplifier headphones in stereo, or if required,
routed into a PA system/powered cabinets.
www.laney.co.uk
9
Advertisement
