Advertisement
L5-STUDIO FEATURES
1
3
1 -
HI INPUT: 'Hi' stands for high gain. This input is designed for the connection of low
output level guitars making it well suited for guitars with single coiled or low gain hum
bucker type pickups. Use of high gain pickups in this input may drive the preamp too
hard causing a "mushy" sound. Only use good quality guitar cable.
2 -
LO INPUT: 'Lo' stands for low gain. This input is attenuated down approximately 50%
from the Hi input and is designed for high output level guitars. It is useful in obtaining
output that is "tight" not "mushy" from high gain humbucker type pickups. Also use this
input for the cleanest full range sound with extended low end response. Only use good
quality guitar cable.
3 -
CLEAN VOL: Sets how loud the clean channel is. Try cranking it up a little to drive the
power tubes harder for that real retro sound and feel that only a quality tube amplifier can
deliver. Now use your guitar volume to control the amount of distortion. (Wind it up for
distortion back it off a little for clean)
BRIGHT: Adds brightness and life to the treble frequencies of your guitar when on the clean
4 -
channel. Adds edge and picking emphasis when on the drive channel. The switch has
more effect at low Clean Volume/Drive control settings. Use in conjunction with the Treble
and Tone controls for optimum performance. Switch up to enable.
3
4
L5-STUDIO USER MANUAL - EN
www.laney.co.uk
Advertisement
