Table of Contents
Advertisement
OPERATION
Leave the appliance in an upright position for 3 hours before
first use.
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead
is rated at 13 Amps or more, and that it is fully unwound.
Switch the unit on at the mains socket.
POWER Button: Press the "Power" button to start the unit.
The Power indicator illuminates when the appliance is ON.
Press the POWER button again to stop the appliance. The
fans and compressor will not stop immediately, but will go
through a shut-down sequence lasting a few seconds.
TEMP+ and TEMP- buttons:
Use the + and - buttons to select the desired zone
temperature. The temperature can be set to any temperature
from 16 ° C to 30 ° C. Selecting a higher temperature will
reduce power consumption. The target temperature is
dislayed in the right-hand two-digit display. The left-hand
two-digit display shows the current room temperature.
For spot cooling, or to select a target temperature below 16
° C, hold down the COOL button for 3 seconds. The display
will then change to "00". The target temperature may now be
adjusted to any value between 0 ° C and 30 ° C.
FAN SPEED button.
Press the FAN SPEED button to change the fan speed.
Page 5
Advertisement
Table of Contents
