Ptt Parameter Mode - Canon PIXMA MX340 Simplified Service Manual

3-2. PTT Parameter Mode

Enter the PTT parameter mode in the user mode as below. (The PTT parameter mode cannot be
entered in the service mode.)
1) In the user mode, press the SCAN button to enter the scan mode.
2-a) Press #, 9, 7, 6, 9, # to enter the PTT parameter mode.
2-b) Press #, 9, 7, 6, 8, # to print the PTT parameter setting value.
- How to finalize the data:
Press the OK button to finalize the data, then press the Stop button to save the data.
- How to exit the PTT parameter mode:
Press the ON button to write the saved data to the EEPROM and turn off the printer.
< PTT parameter mode operation procedures >
1) In the user mode, press the SCAN button to enter the scan mode, and press #, 9, 7, 6, 9, #.
2) The following message is displayed on the LCD:
PTT PARAMETER
#1 BIT SWITCH
BIT SWITCH menu
3) Each time the right or left cursor key is pressed, the menu is changed.
PTT PARAMETER
#2 NUMERIC PARAM.
NUMERIC PARAM. menu
PTT PARAMETER
#3 FAX TYPE
Not used in servicing.
PTT PARAMETER
#4 NCU
Not used in servicing.
PTT PARAMETER
#5 PTT SPECIAL
Not used in servicing.
PTT PARAMETER
#6 FAX TEST
Not used in servicing.
4) Press the OK button when "#1 BIT SWITCH" or "#2, NUMERIC PARAM." is displayed to enter
either of those modes.
(19/37)