Canon Ultura Instruction Manual page 64

Notes:
• TOTAL at the lower right corner of the screen tells you the total running time of
E
all the scenes you have selected.
For best results, when editing from the start of the tape, let the tape run for
about 20 seconds according to the counter. Set the first cut-in point after that.
Also, avoid setting the last cut-out point in the last three minutes of the tape.
• If you program a cut-in point with no cut-out point following, editing will
continue until the tape end and then, the camera and VCR stop automatically.
• Editing a tape recorded in both SP and LP modes may be less accurate.
• Avoid setting the cut-in/cut-out points before non-recorded portions.
• Avoid making the program leaving non-recorded portions between the cuts.
• If, when editing a tape, you set a cut-in point at precisely the start of a still
photo (recorded in Photo Mode), the photo search function may malfunction
later.
64