NEC NEAX 2000 IVS2 Retrofit Manual page 18

• WHEN MAKING A SWITCH SETTING ON A CIRCUIT CARD
CIRCUIT
CARD
• WHEN CARRYING A CIRCUIT CARD
CIRCUIT
CARD
The mark shown below is attached to the sheet for the work in which circuit cards are handled.
When performing such work, the installer must be careful not to cause damage by static
electricity.
NEAX2000 IVS Retrofit System Guide
ND-71075 (E), Issue 1.0
Figure 2-1 Static Electricity Guard (2 of 2)
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
WEAR A WRIST STRAP AND PERFORM
THE WORK ON A GROUNDED
CONDUCTIVE WORK SURFACE.
CONDUCTIVE
POLYETHYLENE
BAG
CHAPTER 2 INSTALLATION
Precautions
WHEN CARRYING A CIRCUIT
CARD AROUND, KEEP THE
CARD IN A CONDUCTIVE
POLYETHYLENE BAG.
Page 13