Installing Desktop Stands; Mounting Rear Satellites On Walls - Cambridge SoundWorks FourPointSurround FPS1500 Installation And Operating Instructions Manual

FPS1500.fm Page 3 Monday, July 10, 2000 3:47 PM
3 Insert attachment arm into socket
1 Apply identification label
at back of satellite.
to back of satellite.
Attachment arm.
3
1
2
3
2
Thread satellite cable through
hole in desktop stand.
4 Apply Identification
label to cable.
5
Mount the rear satellites only on
walls that are structurally sound.
Drill a hole about 0.5 cm (¼
inch) deep into wall.
Tap plastic anchor into hole
until it is flush with wall.
Screw a M5 x 25 mm screw
into anchor, leaving about
0.5 cm (¼ inch) protruding.
Slip keyhole slot of each
rear satellite onto protruding
screw.
Position the satellites behind you
and slightly above ear level.
4 Apply rubber
pads on the
back of each
rear satellite.