Specifications; Fuse Replacement - Cambridge SoundWorks MegaWorks 210D User Manual

SPECIFICATIONS

Analog Input:
775 millivolts for full output
10 kohms input impedance
Digital Input:
Supports 32 kHz, 44 kHz, 48 kHz and 96 kHz data
rates, any word length up to 24 bits.
Amplifiers:
Satellite: 60 watts continuous at 1 kHz, two channels
driven at less than .1% total harmonic distortion.
Subwoofer: 150 watts continuous at 100 Hz, one chan-
nel driven at less than .3% total harmonic distortion.
System Frequency response:
Satellite: 150 Hz to 15 kHz, +/- 3 dB
Subwoofer: 32 Hz to 150 Hz +/- 3 dB
Drivers:
Nominal 8 inch subwoofer driver
Nominal 3.5 inch satellite driver
AC Voltage:
120VAC, 60Hz
Dimensions (H x W x D) and Weights
Satellite (without stand)
4 1/2" x 4 3/8" x 4 7/8"
113mm x 108mm x 125mm
1 pound, 1ounce
482 grams
Satellite (with stand)
6 1/4" x 4 3/8" x 5 5/8"
160mm x 108mm x 143mm
1 pound, 3 ounces
539 grams
Subwoofer
11 1/8" x 10" x 10"
263mm x 255mm x 255mm
14 pounds, 8 ounces
6.6 kg

FUSE REPLACEMENT

IMPORTANT: Turn off and unplug the
speaker before changing the fuse.
Use only with a 250V fuse
Employer uniquement avec
un fusible de 250V
2.
4.
Fuse Replacement
The fuse holder is located in the power connector
at the base of each speaker. The fuse is a 2.5A
MDL type.
To replace the fuse:
1. Unplug the AC cord from the AC power source,
then remove the AC power cord from the speaker's
power connector.
2. Remove the fuse cap with a small, flat blade screw-
driver (see diagram 2).
3. Remove the fuse from the fuse cap
(see diagram 3).
4. Replace the fuse inside fuse cap with another met-
ric 5X20mm size fuse (see diagram 4).
5. Replace the fuse and cap in the power connector
(see diagram 5).
6. Connect the AC power cord to the speaker.
7. Connect the power cord to an AC power outlet.
17
3.
5.