Cleaning And Maintenance - Morphy Richards MRICE15SS Instruction Manual

USING YOUR ICE MAKER
1. Allow the ice maker to warm up to room temperature.
2. It is recommended to replace the water weekly. Please empty the water
reservoir, if the ice maker is not used for a long time.

CLEANING AND MAINTENANCE

To keep your ice tasting fresh and your ice maker looking in great condition, it
is recommended to clean the ice maker at least once per week.
1. Stop the ice making cycle by pressing the Start/Stop button (d). Wait five
minutes and unplug.
2. If residual water is found in the ice tray, gently push the ice tray back so
that all water drains into the water reservoir.
3.
Move the appliance forward 55-60mm away from the working table and
remove the drain tube plug to drain excess water (see Fig.1, Fig.2 and
Fig.3).
4. Check and make sure the drain tube plug is closed securely. Fill the water
reservoir with clean water, press the Ice Size Selector button (e) until the
Appliance Needs Cleaning indicator (c) flashes. Press the Start/Stop button
(d) and the pump will run water for approximately 6 minutes. The Ice maker
will go into standby mode after running for 6 minutes. Finally, remove the
drain tube plug and empty the water out.
5.
Remove the ice basket.
6.
Clean the ice maker interior with a soft cloth soaked with warm water and
vinegar. Then rinse with clean water and drain any remaining water.
7. Replace the drain tube plug securely in position. Wash the ice basket and
ice scoop in warm soapy water. Rinse and dry.
8. Clean the exterior of the ice maker with a soft damp cloth. Use a mild
dishwashing detergent, if necessary.
NOTE: Do not use organic solvent, boiled water, detergent, strong acid and
strong alkali etc. for cleaning.
Please empty the water reservoir and dry it for storage if the ice maker is not
used for a long time.
10