Page 1
Azur 840A (V1 & V2) and 840E Serial Control Protocol V1.1 RS232 Protocol The protocol is accessed via COM1 i.e. the rear panel RS232C port. Command Format Command Header Group 1 to 6 byte num: Notes: All data consists of ASCII bytes.
Commands and Messages 1.4.1 Group 1 - Control Commands Command Command Description Number 01 to 07 Main Input Selects Tape Monitor Main Input Up Main Input Down Power State Mute State Goto Volume Volume Up Volume Down Volume Stop Set Balance Balance Right Balance Left LCD Brightness...
Page 3
1.4.2 Group 2 - Setup Commands Command Command Description Number Get Software Version Get Protocol Version Set Input Name 1.4.3 Group 3 - Replies from Setup Commands Command Command Description Number Software Version Protocol Version Input Name Changed Gallery Court, Hankey Place, London SE1 4BB England Tel: +44 (0)20 7940 2200 Fax: +44 (0)20 7940 2233 Web: www.cambridge-audio.com Command Data No Data No Data...
Page 4
1.4.4 Group 4 - Replies from Control Commands and Updates Command Command Description Number 01 to 07 Main Input Source Changed Tape Monitor Changed Power State Changed Mute State Changed Volume Changed Volume Increasing Volume Decreasing Volume Stopped Balance Changed LCD Brightness Changed Speaker Selection Changed Headphones In / Out...
Page 5
Command Data Error Information in this document has been carefully checked for accuracy; however, Cambridge Audio's policy is one of continuous improvement, therefore design and specifications are subject to change without prior notice. If you notice any errors please feel free to email us at: This document contains proprietary information protected by copyright.