Configuring Your Machine For A Wireless Network; Using The Setup Wizard From The Control Panel - Brother NC-130h Network User's Manual

Network key
There are some rules for each security method:
Open system/Shared key with WEP
This key is a 64-bit or 128-bit value that must be entered in an ASCII or HEXADECIMAL format.
64 (40) bit ASCII:
64 (40) bit hexadecimal:
128 (104) bit ASCII:
128 (104) bit hexadecimal:
WPA-PSK/WPA2-PSK and TKIP or AES
Uses a Pre-Shared Key (PSK) that is more than 7 and less than 64 characters in length.

Configuring your machine for a wireless network

There are three methods to configure your wireless network machine; by using the machine control panel
(recommended), using the SecureEasySetup™ software and using the automatic installer application on the
CD-ROM.

Using the Setup Wizard from the control panel

You can configure your print server by using the Setup Wizard function. This is located in the LAN menu
on the machine's control panel. See to the steps below for further information.
a
Press Menu.
b
Press a or b to select LAN.
Press OK.
c
Press a or b to select Network I/F.
Press OK.
d
Press a or b to select WLAN.
Press OK. The wireless network interface will be activated.
e
Press a or b to select Setup WLAN.
Press OK.
f
Press a or b to select Setup Wizard.
Press OK.
g
Start to search for a SSID around the machine.
Configuring your machine for a wireless network
Uses 5 text characters.e.g. "WLLAN" (this is case sensitive).
Uses 10 digits of hexadecimal data.e.g. "71f2234aba"
Uses 13 text characters.e.g. "Wirelesscomms" (this is case
sensitive)
Uses 26 digits of hexadecimal datae.g.
"71f2234ab56cd709e5412aa2ba"
3
3
3
3
20