Brother MFC-8670DN User Manual page 131

Error Message Cause
DR Mode in Use The machine is set to Distinctive
Ring mode. You can not change
the Receive Mode from Manual to
another mode.
The drum unit is near the end of its
Drum Near End
life.
The drum counter was not reset
when a new drum was installed.
The duplex tray is not installed
Duplex
properly.
Disabled
The primary corona wire on the
Dust on Drum
drum unit needs to be cleaned.
The temperature of fuser unit does
Fuser Error
not rise at a specified temperature
within specified time.
The fuser unit is too hot.
The machine is out of paper or
No Paper
paper is not properly loaded in the
paper tray.
The number you dialed does not
No
answer or is busy.
Response/Busy
The paper tray is not completely
No Tray
closed.
You tried to access a One-Touch or
Not
Speed Dial number that is not
Registered
programmed.
Troubleshooting and routine maintenance
Action
Set Distinctive Ring to Off. See Turning off
Distinctive Ring on page 48.
Use the drum unit until you have a print quality
problem; then replace the drum unit with a new
one.
See Replacing the drum unit (DR-520) on page
135.
1. Open the front cover, and then press
Clear/Back.
2. Press 1 to reset.
Remove the duplex tray and install it again.
Clean the primary corona wire on the drum unit.
(See Cleaning the corona wire on page 130.)
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine for
15 minutes with the power on. (The machine can
be turned off for up to 4 days without losing faxes
stored in the memory. See Checking if the
machine has faxes in its memory on page 120.)
Do one of the following:
Refill the paper in the paper tray or MP tray.
Remove the paper and load it again.
Verify the number and try again.
Close the paper tray properly.
-
Set up the One Touch or Speed Dial number.
(See Storing One-Touch dial numbers on page
57 and Storing Speed-Dial numbers on page
59.)
117