(2) Please select the MCU type to in "Project/Setup Project.../MCU".
(3) In "Project/Setup Project.../Linker", set "Disposition/Connection" in Category, then select
_INROM01 and click "Set Section..." After that, a dialog window will pop up as shown in
Figure 4.6 below. Set Const (named @INIT) and Dirconst (named @DIRINIT) as shown
in Figure 4.7 and Figure 4.8.
SOP28 PGM ADAPTOR V1.0
Chapter 4 Program Function
Figure 4.7: Set MCU Type
MCU-AN-500076-E-10– Page 15
Select MCU