Care And Cleaning - Cafe BELLISSIMO C7CESAS3RD3 Owner's Manual

Care and Cleaning

WARNING
injury and disconnect power prior to cleaning or service.
CAUTION
hot steam, do not touch liquids or steam wand during or after frothing. Do not
remove pitcher until steaming is complete. Hold milk pitcher by the handle
Cleaning your Espresso Machine
■ Unplug the espresso machine from the wall.
■ Pour out all water left in the water tank and drip tray. Wash and air or towel dry.
■ Wipe down appliance using a non-scratch cloth and non-abrasive cleaner.
■ DO NOT place any part of the espresso machine in the dishwasher. Hand wash only.
NOTE: When not in use for long periods of time, such as vacation, run System Empty Cycle, dry
water tank, and open water tank lid.
Clean / Descale
Descale process consists of 2 stages and will take approximately 30 minutes. Alert will turn off after
both stages are completed.
DO NOT use any cleaning agents not provided with the product or recommended in this manual.
STAGE 1:
1. Fill third of the water tank with water.
2. Add one pack of cleaning solution in the water tank (one tablet or packet). Mix well.
3. Place a sufficiently large container under the Brew Head and Steam Wand.
4. Press and hold the GRIND and DOUBLE buttons for 3 seconds to initiate. CLEAN alert flashes.
5. Rotate the control knob to Steam. Water starts dispensing.
6. After Add Water LED turns on, rotate the control knob to the neutral position.
STAGE 2:
1. Remove, rinse , fully refill, and reinstall the water tank.
2. Repeat steps 3, 5, and 6 from STAGE 1.
3. Refill the water tank. Unit is ready for normal operation.
NOTE: As an alternative, a 1:1 ratio of water and white vinegar can
be used as a cleaning solution for the descaling process.
Cleaning the Grinder
Be sure to place a cup or container under the grinder when
completing this process to collect loose grounds of coffee. It is
recommended to clean the grinder at least once a week.
■ Remove the hopper from the espresso machine.
■ Rotate to unlock and pull out the Outer Burr.
■ Use the brush provided to wipe away any grounds from
the grinder. Make sure to clean the grinder from top and
bottom of the grinder chute.
■ Place the outer burr back into the machine.
■ Place the hopper back into place.
NOTE: Do not use hands to wipe away grounds, only use
the brush provided.
Allow heating element to completely cool to avoid risk of fire or
To avoid possible burns to body parts and/or other injury from
Cleaning brush
14
.
Outer burr