Advertisement
You can easily open or close your kiln's door using the simple stainless steel "spring" latch on the
door (Pic. 14).
Pic. 14:
Now your kiln is assembled. Close the shutter on the door (Pic. 15) to avoid heat leaking out
from inside of the chamber. Plug the mains cable into a power supply to start using your
kiln.
When using the kiln for the first time, it must be heated up for approximately 90 minutes
(factory setting) to allow any water to evaporate from the chamber. Please do not be
alarmed if light smoke and/or a smell appears (when using the kiln for the FIRST time). This
is normal for new kilns as any water, grease or oils burn out from the heating element(s),
shelves, chamber and from inside the kiln. It should not happen again after the first time it is
heated. If your kiln is used less than once a month then please repeat this process each
time you use it.
Please also note that the temperature shown on the controller is the temperature around the
thermocouple(s) inside the kiln's chamber. You may have to wait up to two hours for the in-
side of your kiln to heat up fully and reach the same temperature everywhere inside the
chamber.
USABLE CHAMBER DIMENSIONS:
grams of the kiln's chamber (inner).
PIC. 19:
4
Pic. 15:
Below (Pic. 19) you can see FRONT AND TOP VIEW dia-
Advertisement
