Installation And Replacement - Emerson PACSystems RX3i User Manual

PACSystems™ RX3i Battery & Energy Pack User Manual
GFK-2741K
charging jack into the threaded connector on the side of the battery and hand tighten the
screw lock to secure it.
2.7.3

Installation and Replacement

1. Access the battery compartment on the CPU by opening the door (RX3i) or
2. Turn on power and wait for the CPU to complete its initialization. Initialization is
3. Connect the battery to either of the battery connectors on the CPU. If replacing an
4. For Coin Cell batteries, secure the battery in the compartment and close the
5. For auxiliary batteries and the rechargeable battery, route the battery cable
Be careful not to pinch the battery cable when closing the battery compartment cover.
Figure 5: RX3i Battery Installation
Batteries
removing the battery cover (RX7i) - (refer to the following battery installation
figures).
complete when the OK LED on the CPU remains on.
existing battery, connect the new battery to the other connector before
disconnecting the old battery (be careful to not disconnect the old battery until the
new battery is connected). Properly discard the old battery per disposal instructions
(Refer to the section Safe Handling & Disposal).
compartment door (RX3i) or install the battery cover (RX7i).
through the notch in the base of the battery compartment (RX3i) or the slot in the
bottom of the battery cover (RX7i) and close the compartment door (RX3i) or install
the battery cover (RX7i).
Section 2
Feb 2021
16