Setting Of Environment - Brother BE-0901E Settings Manual

B E
B E
Thread trimming length
thread trim. The lower the number the shorter and the higher the number the longer it is.
Default setting is 4.
Recommended setting is 4.
Thread removal feed length and Inching
Thread removal feed length
add in removal of the cut thread from the fabric.
Default is 15mm.
Recommended setting is 20mm.
Inching
thread trim. When the machine is doing the inching stitches the thread break sensor is
momentarily turned off to reduce false thread breaks.
Default setting is ON.
Recommended setting is ON.
Resetting of thread breakage error
break.
Auto – Machine will beep 2 times and then automatically back up.
Recommended setting unless you like the machine to beep continuously until
pressing the STOP key.
Manual – Machine will beep continuously until the operator presses the stop key. Then
the machine will back up.
Default setting, machine will beep until you press the STOP key.

Setting of Environment

First page of settings
Return to start point after embroidery end
the design the same as the start point. Corrects older designs that may have the two
points a little off.
Default setting is ON.
Recommended setting is ON.
Method of reflecting modified machine speed
change the sewing speed for all needles on the machine or just the needle you are
sewing with at the time.
Default is ALL NEEDLES.
Recommended setting is ALL NEEDLES.
Method of checking embroidery area
shape is used to represent the shape of the design when tracing. Rectangular is quicker
but will not represent the true shape of a circular design like octagon will.
Default setting is RECTANGULAR.
Recommended setting is OCTAGON.
- 1 0 1 , 9 1 6 ,
- 1 0 1 , 9 1 6 ,
For Technical Assistance Please Call Toll Free 1-877-4BROTHER
Machine Settings
– determines the length of thread left out of the needle after a
– Slow sewing speed of 100 - 120 spm when the machine starts up after a
2
9 0 1 , 1 2 1 6 ,
9 0 1 , 1 2 1 6 ,
– How much the pantograph moves after a trim to
– How the machine reacts when it has a thread
– This will make the end point of
– Do you want the machine to
– Whether a rectangular or octagon
1 2 0 1 A C
1 2 0 1 A C