Setting Up The Pxi-8150 - National Instruments PXI-8150 Series Getting Started

3
2
1
1 Injector/Ejector Handle
2 PXI Board

Setting up the PXI-8150

© National Instruments Corporation
4
1
3 PXI-8156 System Controller
4 PXI-1000 Chassis
Figure 2-1. PXI Mainframe and Controller
At Windows 95/NT startup, the software prompts you to insert a disk to
configure the system for LabVIEW or LabWindows/CVI, and to enter
the serial number for the operating system. These programming
environments are already installed on your system but you must insert
a configuration disk when prompted so that you can access and use
them. If you ordered either of these programming environments, select
O N
S T
A N
D B
2
3
4
5
6
7
8
5
2-3 Getting Started with Your PXI-8150 Series
Chapter 2
Y
5 Injector/Ejector Rail
Setup