Improving The Print Quality - Brother HL-5270DN User Manual

Improving the print quality

If you have a print quality problem, print a test page first (see Menu table on page 56). If the printout looks
good, the problem is probably not the printer. Check the interface cable or try the printer on another PC.
This section gives information on the following topics.
Examples of poor print
quality
ABCDEFGH CDEF
abcdefghijk defg
A B C D B C
a b c d e b c d
0 1 2 3 4 2 3
Faint
ABCDEFGH
abcdefghijk
A B C D
a b c d e
0 1 2 3 4
Gray background
Ghost
ABCDEFGH
abcdefghijk
A B C D
a b c d e
0 1 2 3 4
Toner specks
Recommendation
Check the printer's environment. Conditions such as humidity, high
temperatures, and so on, may cause this print fault. See Positioning the printer
on page 4.
If the whole page is too light, Toner Save Mode may be on. Turn off Toner Save
Mode in the printer Properties tab of the driver.
Put in a new toner cartridge. See Replacing the toner cartridge on page 75.
Put in a new drum unit. See Replacing the drum unit on page 80.
You may clear the problem by wiping the scanner window with a soft cloth.
See Cleaning the inside of the printer on page 86.
Make sure that you use paper that meets our specifications. See About paper on
page 6.
Check the printer's environment. Conditions such as high temperatures and high
humidity can increase the amount of background shading. See Positioning the
printer on page 4.
Put in a new toner cartridge. See Replacing the toner cartridge on page 75.
Put in a new drum unit. See Replacing the drum unit on page 80.
Make sure that you use paper that meets our specifications. Rough-surfaced
paper or thick print media may cause this problem. See About paper on page 6.
Make sure that the media type setting in the driver matches the type of paper you
are using. See About paper on page 6.
Put in a new drum unit. See Replacing the drum unit on page 80.
The fuser unit may be contaminated. Call Brother Customer Service.
Make sure that you use paper that meets our specifications. Rough-surfaced
paper may cause the problem. See About paper on page 6.
The drum unit may be damaged. Put in a new drum unit. See Replacing the drum
unit on page 80.
The fuser unit may be contaminated. Call Brother Customer Service.
7. Troubleshooting
105