Table of Contents
Advertisement
Troubleshooting and
Common Questions
Troubleshooting Diagnostic Utility Failures
Missing Software Components
No GPIB Interfaces Present
© National Instruments Corporation
This appendix contains troubleshooting information and the answers to
common questions.
The following sections explain common error messages the Diagnostic
utility generates.
This error occurs if the software components that are necessary for the
GPIB software for Windows NT to function correctly are not present in
the system. If you encounter this problem, reinstall the GPIB software for
Windows NT and run the Diagnostic utility again.
This error occurs if there is no PC/104-GPIB physically present in the
system or there is a resource conflict with the interfaces that are installed.
If you encounter this problem, use the GPIB Configuration utility to
examine any installed GPIB interfaces and the resources assigned to
each. Then, run the Diagnostic utility again.
To access this information in the GPIB Configuration utility, complete
the following steps:
1.
Double-click on the GPIB icon in the Control Panel.
Windows NT 3.51: Open the Control Panel in the Main group of
the Program Manager.
Windows NT 4.0 or higher: Select Start»Settings»Control Panel.
A-1
Appendix
A
PC/104-GPIB for Windows NT
Advertisement
Table of Contents
