Windows ® 2000/Xp Printing (Printer Driver Already Installed) - Brother DCP-315CN Network User's Manual

®
9
Windows 2000/XP will now contact the printer that you
specified. If you did not specify the correct IP address or name
then you will receive an error message.
10
Click the Finish button to complete the Wizard.
11
Now that you have configured the port, you must specify which
printer driver you wish to use. Select the appropriate driver from
the list of supported printers. If you are using a driver supplied
with the machine on CD-ROM then select the Have Disk option
to browse to the CD-ROM.
12
Select the "X:\ENG\W2K\Addprt" folder (where X is your drive
letter). Click on Open, then OK. Select your printer model, then
click Next (example is for Windows
13
When the driver is installed, click the Next button.
14
Specify a name and click the Next button.
15
Now specify if you wish to share the printer, enter the share
name and click Next.
16
Continue through the Wizard clicking the Finish button when
complete.
®
Windows 2000/XP Printing
(Printer Driver already installed)
If you have already installed the printer driver and wish to configure
it for network printing, follow these steps:
1
Select the printer driver you wish to configure.
2
Select File and then choose Properties.
3
Click the Ports tab of the driver and click Add Port.
4
Select the port that you wish to use. Typically this would be
Standard TCP/IP Port. Then click the New Port... button.
5
The standard TCP/IP Port Wizard will start. Follow steps 6 to
10 of the "Standard TCP/IP Port Printing" section starting on the
previous page.
NETWORK PRINTING FROM WINDOWS
®
2000).
®
(Peer to Peer) 4 - 3