Print Quality Check - Brother DCP-120C Quick Setup Manual

STEP1
Setting Up the Machine
5

Print quality check

1
After the cleaning cycle is finished, the LCD
shows:
Set Paper and
Press Start
2
Make sure the paper is loaded in the paper
tray.
Press Color Start.
The machine starts printing the Print Quality
Check Sheet (only during initial ink cartridge
installation).
3
Check the quality of the four color blocks on the
sheet.
(black/ cyan/ yellow/ magenta)
1. Check the quality of the four-color blocks formed by the short lines.
2. If all the short lines are clear and visible, the quality is acceptable. the quality is acceptable.
Select (Yes). If you can see missing short lines, select (No) to begin the color cleaning process
and follow the prompts on the LCD.
Improper Setup
Avoid touching the printed surface of the
paper immediately after printing, the surface
may not be completely dry and may stain your
fingers.
8
q
Print Quality Check
4
The LCD shows:
Is Quality OK?
q
a Yes b No
5
Do one of the following:
If all lines are clear and visible, press a
(Yes) to finish the quality check.
If you can see missing short lines, press b
(No) and go to step 6.
OK
6
The LCD asks you if the print quality is OK for
black and color. Press a (Yes) or b (No) .
Black OK?
q
a Yes b No
After pressing a (Yes) or b (No) for both black
and color, the LCD shows:
Start Cleaning?
q
a Yes b No
7
Press a (Yes), the machine will then start
cleaning the colors.
8
After cleaning is finished, press Color Start.
The machine starts printing the Print Quality
Check Sheet again and goes back to step 3.
Poor