Advertisement
www.Ninjapaintball.com
SETTING UP THE NINJA DIN 300 PCP FILL
The Ninja DIN 300 connects high pressure air bulk cylinders or N2 bulk
cylinders to a Pre-charged Pneumatic (PCP) airgun.
On the backside of the fill station is a vent port.
▲ FOR SAFETY REASONS, THE FILL PORT MUST BE DIRECTED
AWAY FROM THE OPERATOR AND BYSTANDERS.
Do not over tighten the vent knob as this may damage the
seal. Only turn the knob enough to stop the release of gas.
▲ Never operate the PCP Fill Adapter unless a PCP AIR RIFLE is
attached to the fill adapter on the end of the fill hose. Operating
the PCP Fill Adapter without a PCP AIR RIFLE attached will
cause the fill hose to "whip". Injury may result!!
1.0 OPERATION with a HIGH PRESSURE BULK AIR CYLINDER OR N2
THIS FILL ADAPTER WILL VENT GASES STORED UNDER HIGH
PRESSURE MAKE CERTAIN THE VALVE VENT KNOB (part #2) IS
CLOSED (turned fully clockwise) BEFORE CONNECTING TO A HIGH
STATION
PRESSURE BULK AIR CYLINDER.
2
Advertisement
