Jayco Jay Feather 2005 Owner's Manual page 62

At Camp...
gas connection are installed on your trailer as standard equipment. The following list will
supply basic operations for the grill. Make sure to read, understand an follow all
instructions included with the BBQ grill.
1. Install the grill bracket on the support bracket
installed on the side of your trailer. Make sure that it
is securely placed on the support bracket.
2. Place the BBQ grill into the grill bracket.
3. Attach the fuel hose from the grill to the "quick
coupler" LP gas connection as directed above.
4. Open the lid to the BBQ grill.
5. Using and electric match, light the grill using the
following procedures:
= Light the electric match.
= Insert it into the middle slot on the bottom of the
BBQ grill.
= On the BBQ grill control knob, depress and turn
the knob to the desired temperature.
= The grill should light at this point.
6. If the grill does not light, turn the gas off, wait five
(5) minutes and repeat the above steps.
7. Use the temperature control knob to adjust the grill
to the desired temperature.
The BBQ grill grate is coated with standard grill enamel
and can be cleaned as you would a grill at home. Underneath the grate, there is a heat
diffuser. This is formed and ventilated to distribute the heat from the burner. Do not use
lava rocks in this grill.
To disconnect the BBQ grill, turn the temperature control to OFF. Reverse the above fuel
hose hookup procedures. Wait until the grill is completely cooled, then store it in the
supplied carrying case. This carrying case will ONLY accommodate a cool grill. The grill
carrying case has a pocket for accessories such as the fuel hose in the lid. The bracket will
not fit inside the carrying case and will need to be stored in a separate location.
I
CAUTION: The BBQ grill must be COMPLETELY cooled before
storing to avoid damaging the carrying case and causing injury from
handling the grill when it is hot.
52
Fig. 18
Fig. 19
Jay Feather Conventional Travel Trailer