Charging The Shaver; Indicator Lights - Braun 4615 User Manual

Technical specifications
Wattage via low voltage adapter:
4 W, input voltage 120 V ac / 50-60 Hz
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Foil frame
5 Release buttons
6 Long hair trimmer
7 Central switch
8 Low charge light
9 Charging light
10 Shaver socket
11 Low voltage adapter

Charging the shaver

• Via the low voltage adapter, connect
the shaver to an electrical outlet with
the motor switched off. Charge for at
least 8 hours (adapter and shaver
might get warm). Once the shaver is
completely charged, shave until fully
discharged. Then recharge to full
capacity again.
• A full charge will give up to 25
minutes of cordless shaving time
depending on your beard growth.
However, the maximum battery
capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature
range for charging is 60 °F to 90 °F/
15°C to 35°C.

Indicator lights

• The green charging light shows that
the shaver is being charged.
• The red low charge light will come on
when the battery capacity has
8
dropped below 20%, provided the
shaver is switched on. The remaining
capacity will then be sufficient for 1 to
2 shaves.
Shaving
Turn on the shaver («on»).
Trimmer («trim»): When the long hair
trimmer is activated, it allows the
controlled trimming of moustache or
sideburns.
Tips for the perfect shave
• We recommend that you shave
before washing, as the skin tends to
be slightly swollen after washing.
• Hold the shaver at right angles (90°)
to the skin. Stretch your skin and
shave against the direction of beard
growth.
• To ensure optimum shaving per-
formance, we recommend to re-
place the shaver foil and cutter
block every 18 months, or when
the parts are worn.
Keeping your shaver in top
shape
Before cleaning, always unplug the
shaver.
Cleaning under running water
After each shave, turn on the shaver
and clean it under running hot water.
Occasionally use soap (natural based
liquid soap without particles and
abrasive substances). Then rinse off all
foam and let the shaver run for another
moment.
Brush cleaning
Instead of cleaning under running water,
you may clean your shaver with a dry