Advertisement
Cordless shaving/charging
When charging the shaver for the first time, connect it to
the mains (100 - 240 V) and charge it for 4 hours to full
capacity. Then discharge the shaver through normal
shaving until the low-charge light
Recharge the shaver for 1 hour.
This charging method preserves the maximum capacity
of the cell unit. All subsequent charges will also take
only 1 hour (quick charging). The shaver automatically
adapts to all direct and alternating current voltages
(12 - 240 V) and to frequencies of 50 or 60 Hz.
Recharging on 12 V (–) in cars or boats, takes
approximately 20 hours. The surrounding temperature
should not exceed + 25 °C.
A full charge will give up to about 70 minutes of cordless
shaving (approximately 20 days based on 3.5 minutes
per shave), depending on the thickness of your beard.
State of the shaver and
The LCD function display
the state of the shaver and the rechargeable cell unit,
cell unit
also taking into account the normal self-discharge.
The cell unit is discharged; nothing is shown on the
display. The shaver does not work.
The cell unit is discharged, but the shaver is connected
to the mains. The green charging light
After 60 minutes of charging all segments are on the
LCD display
The cell unit is charged to full capacity.
The cell capacity is shown in 20 % steps, e. g. charged
up to 40 % capacity: the segments 20 % and 40 % are
shown.
Less than 20 % capacity: half of the 20 % segment and
the figure «9» (showing the remaining minutes) are on
the display. When the shaver is switched on, the low-
charge light
The figure «0» is on the LCD display, and the motor
stops. Recharge the shaver at this point at the latest.
Preserving the cell unit
The shaver preserves the cell unit automatically. About
once a year the shaver discharges and recharges the
cell unit automatically, if connected to the mains. This
procedure takes approximately 7 hours.
4
b
lights up.
2
b
B
and the lights
,
show
B
is on.
2
B
. The green charging light
goes off.
b
flashes too.
Connect the shaver to the mains and turn the shaver on
3
(see switch
). If the shaver should not run immediately
– because of the discharged cell unit – leave it plugged
3
in with the switch
set to «0», for approximately 1
minute. Thereafter, you can shave with cord plugged
into the outled.
Notice: Shaving directly via the cord on voltages below
100 V (in cars, boats etc.) is not possible.
8
• Take off the foil protection cap
.
3
• For shaving, push the switch
to setting «1».
• Hold the shaver at right angles (90°) to the skin.
• Stretch the skin with your free hand.
• Guide the shaver smoothly against the direction of
beard growth, applying only gentle pressure.
G
The pivoting cutting system (twin foil
g
longhair cutter
follows the contours of your face
automatically.
While shaving difficult parts of your face (e. g. under the
3
nose or at the hairline), push switch
to setting «2», to
lock the pivoting head at an angle.
To activate the longhair trimmer, move the switch
setting «3». The longhair trimmer moves upwards and
allows easy and exact trimming of the side burns.
3
Move the switch
back to setting «0».
Important: After every shave, put the foil protection cap
8
on the pivoting head.
Shaving with the cord
Shaving
and integrated
3
to
Longhair trimmer
Switching the shaver off
4
5
Advertisement
