Table of Contents
Advertisement
PARTS OF THE SYSTEM
• (1) Filter system w/integrated mounting bracket and (3) installed filtration cartridges
• Installation Hardware Kit (contains mounting screws, saddle valve, flow restrictor and fittings)
• Manual
• (1) Tubing Kit (containing 1/4-inch tubing)
• (1) Lead-free faucet (including hardware)
• (1) Housing wrench
MATERIALS AND TOOLS NEEDED
Notice
Gather the required tools before starting installation. Read and follow the instructions
provided with any tools listed here.
• Safety glasses
• Hand or electric drill (cordless recommended)
• File or sandpaper
• Phillips Head screwdriver
• (2) Two adjustable wrenches
• Tube cutters or utility knife
**If sink does not have hole for separate faucet:
• Center punch
• 3/4-inch (19mm) drill bit
• Masking tape
IMPORTANT: To avoid damaging the sink, consult a qualified plumber or installer for drilling procedures
in porcelain, granite, or stainless steel.
INSTALLATION INSTRUCTIONS
Notice
• A squeaking sound when tightening a compression nut is normal.
• If fittings are removed, plumber's tape must be used for pipe threaded connections.
• Be sure to wear safety glasses when using a drill.
• Typical faucet shown. Faucet will vary.
• System is designed for standard under-sink installation on 3/8"-inch (10mm) cold water line.
• Numbered diagrams correspond with numbered steps.
Step 1 – Installing the Saddle Valve
Use of a cordless drill is recommended. To protect yourself from serious injury or fatal
shock when using an electric drill, be sure the drill and the outlet it is plugged into are
properly grounded. When using a drill, follow the manufacturer' s guidelines and procedures.
Notice
Saddle valve must be installed on a 2-inch (51mm) long, straight-walled section of
3/8-inch to 7/8-inch (10-22mm) steel, brass, copper, or PVC pipe
a) Turn off cold water supply and turn on nearest faucet before starting installation.
Place a tray or towels under the cold water line to catch excess water.
b) Drill a 1/8-inch (3mm) hole in the cold water line. Remove any burrs with
sandpaper or file.
c) Turn handle on the saddle valve to expose lance no more than 3/16-inch (5mm)
above black rubber gasket.
d) Place valve body over hole in cold water line so lance fits into hole.
e) Attach back plate of clamp and tighten bolts evenly and firmly so
brackets are parallel.
f) Turn valve handle clockwise to closed position and leave closed until
installation is compete.
Notice
All nuts must be retightened when the system reaches projected
operating temperature.
5 • PDF-1000VF-P 3-STAGE DRINKING WATER SYSTEM
Advertisement
Table of Contents
