Siemens LI 12530 Operating And Installation Instructions page 26

Installation inside the wall cupboard
1. Align the cupboard doors if the hinges
will no longer be accessible after the
extractor hood has been fitted.
2. Place the extractor hood onto the
mounting brackets and push it into the
cupboard.
Important: The extractor hood must be
firmly seated on the 4 mounting
brackets.
3. Loosely screw in the 4 enclosed screws.
Align the extractor hood and then
tighten screws.
Check that the extractor hood is firmly
fitted into the cupboard.
26
4. Install a shelf immediately above the
extractor hood. Cut holes for the pipe
connection and the mains cable.
If the shelf is permanently fixed inside
the cupboard, 4 holes must be drilled to
provide access to the 4 mounting screws
for the extractor hood.
5. Route the mains cable through the hole
in the wall cupboard and connect up the
exhaust pipe.
6. Connect up the extractor hood to the
mains.
7. If no handle is going to be attached to
the vapour extractor, seal off the 3 holes
with the enclosed caps.