Cleaning And Care; Replacing The Light Bulb - Siemens LI 12530 Operating And Installation Instructions

Cleaning and care

Isolate the extractor hood by pulling out
the mains plug or switching off the fuse.
Do not clean the extractor hood with
abrasive sponges or with cleaning agents
which contain sand, soda, acid or chlorine!
Notes:
❑ Do not apply force to the air flap when
cleaning the inside.
❑ The air flap may not be moved by hand.
❑ Clean the extractor hood with a hot soap
solution or a mild window cleaner.
❑ Do not scrape off dried-on dirt but wipe
off with a damp cloth.
❑ When cleaning the grease filters, remove
grease deposits from accessible parts of
the housing. This prevents the risk of fire
and ensures that the extractor hood
continues operating at maximum
efficiency.
Clean the operating buttons with a mild
soapy solution and a soft, damp cloth only.
Do not use stainless-steel cleaner to clean
the operating buttons.
Stainless steel surfaces:
❑ Use a mild non-abrasive stainless steel
cleaner.
❑ Clean the surface in the same direction
as it has been ground and polished.
❑ We recommend our stainless steel
cleaner no. 461731.
See enclosed service booklet for order
address.
Aluminium and plastic surfaces:
❑ Do not use dry cloths.
❑ Use a mild window cleaning agent.
❑ Do not use aggressive, acidic or caustic
cleaners.
Observe the warranty regulations in the
enclosed service booklet.
For appliances with a glass plate in the
pull-out vapour extractor:
❑ The glass plate is easily removed and
can be cleaned in a dishwasher.
❑ To remove the lugs, push outwards.

Replacing the light bulb

1. Switch off the extractor hood and pull
out the mains plug or switch off the
electricity supply at the fuse box.
2. Pull out the extractor hood and detach
the filter frame.
3. Replace the light bulbs. (Standard
candle bulbs, max. 40 W, E14 socket).
4. Re-attach the filter frame.
5. Plug appliance into mains again or
switch on at the fuse box.
21