Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the hour setting
starts to flash.
This causes the hours digit to flash.
This is the setting mode. The hands
●
automatically shift out of the way for
easy viewing of the display and other
indicators.
Hours
3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
Watch Operation Guide 5663
4.
Press (C).
This causes the minutes digits to flash.
5.
Use (B) and (D) to change the minutes
setting.
6.
Press (C).
This causes the seconds digits to flash.
7.
Use (B) and (D) to change the seconds
setting.
8.
Press (A) to complete the setting
operation.
Note
Setting a start time of [0:00 00] will
●
perform a countdown of 24 hours.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Minutes
Seconds
Using the Timer
1.
Enter the Timer Mode.
Navigating Between Modes
l
Hour, minute
Seconds
2.
Use the operations below to perform a
timer operation.
D
Start
(Measurement operation starts.)
D
Pause
D
Resume
(Time up)
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
You can reset a paused countdown to
●
its start time, by pressing (A).
3.
Press any button to stop the tone.
13