Toto Legato TL624DD Installation And Owner's Manual page 5

NO TE: Be sure to install the hot handle and valve on the left side and the cold handle
and valve on the right.
1) Disassemble the deck adapter from the
valve unit.
2) Turn the lock nut as far down the valve as
possible.
3) Insert the valve unit in the order shown
in Illustration 3 (from the underside of
the deck through the mounting hole).
Screw in the deck adapter from above
the deck until it bottoms out.
4) Secure the valve unit with the lock nut
and screws.
5) Insert the handle unit, adjust the handle
so that the hot and cold markings are
displayed correctly, then secure the
handle with the set screw.
6) Repeat the above procedure for the
other valve and handle.
7) Clean the supply line thoroughly and
connect the valve to the supply line.
8) Connect the flex hoses to the spout unit
and valve unit.
INSTALLATION PROCEDURE
Handle Installation
Deck
Adapter
Valve
5
Illustration 3
Handle
Unit
Gasket
Deck
Rubber Washer
Metal Washer
Sleeve
Metal Washer
Lock Nut