Maintenance - Panasonic FV-SCGPW1 Operating And Installation Instructions

How to Operate (Continued)
Change operation modes
Touch to change the operation modes.
Reset Filter sign (Maintenance of the ventilator)
The filter sign lights up when it is time to clean or replace the ventilator filter.
After it is cleaned or replaced, follow the step below to reset the filter sign.
Sign Maintenance details
Clean the filter.
Replace the filter.
Clean and replace the filter.
■ Reset operation
Touch and hold
turns off (3seconds or longer).
※Refer to the manual of the ventilator for the maintenance method.
※In case that only the ventilator has been used before connecting the controller to it,
the Filter sign may light immediately after the controller connection.

Maintenance

Before maintenance, turn off the ventilator and the breaker.
•
Periodically clean and wipe the front cover (particularly for the side slits) with a dry cloth to
•
prevent accumulation of dust.
Notice
Do not use household alkaline synthetic detergents for the product.
•
The resin part may be discolored or damaged.
6
English
Operation modes
Auto : This mode detects CO
•
the sensors to switch the air volumes according to
their concentration.
Silent : This mode reduces the air volume and operates more
•
quietly than Auto mode. The sensors detect CO
PM2.5 in the room and the air volumes are switched
according to their concentration.
Manual : This mode operates the ventilator with the set air volume.
•
Users can adjust the air volume by touching
Low
until the Filter sign
and PM2.5 in the room with
2
(3 seconds or longer)
and
2
or .
High