Setting the clock
1.
To change the clock setting, press and hold the ENTER button (2).
The hour and minutes display will begin flashing.
Setting the time
After pressing ENTER, to change the time, press I<< / >>I (1) to
correct the time. To switch between hour and minutes settings, press
ENTER again. To enter the normal mode, press ENTER or wait few
seconds.
Setting the time display mode
After pressing ENTER, to switch between 24 hour mode and 12 hour
mode ( AM/PM
mode), by pressing and hold ENTER until the display
mode changes.
2.
- 12 -
Detachable Control Panel(D.C.P)
Removing The Detachable Control Panel (D.C.P.).
Attaching the DCP
A
B
CAUTION
DO NOT insert the D.C.P from the left side. Doing so may damage it.
The D.C.P can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop
it or subject it to strong shocks.
When the release button is pressed and the D.C.P is unlocked, the car's vibrations may cause it to fall. To prevent
damage to the D.C.P , always store it in a protective case after detaching it.
The rear connector that connects the main unit and the D.C.P is an extremely important part. Be careful not to
damage it by pressing on it with fingernails, pens, screwdrivers, etc.
Socket
1. Turn the power off
2. Press the D.C.P . release button
3. Remove the D.C.P .
1. Attach the panel at the right side first, with
point B on the main unit touching point A on
the D.C.P . (As shown on the digram).
2. Then press the left side of D.C.P . onto the main
unit until a
click sound is heard.
Note:
If the D.C.P is dirty, wipe off the dirt with soft,
dry cloth only. And use a cotton swab soaked
in isopropyl alcohol to clean the socket on the
back of the D.C.P .
- 5 -