Table of Contents
Advertisement
SOFTWARE UPDATES
To enable the GCP programming or Calibration, first unlock the screen from the WebUI by pressing the
Unlock button.
Figure 6-13 WebUI Unlock
The WebUI will show the message below on the left, asking for confirmation to continue. Select OK and
the WebUI will show the message below on the right.
Figure 6-14 WebUI Confirm Local User Presence
At this point, the display module will show the message in the following figure to the user in the field. The
user in the field will press Enter to confirm that the remote user may continue, or the local user may deny
the remote user editing access by pressing the back key.
Figure 6-15 Display Confirm Local User Presence
6-9
SIG-QG-20-02
JANUARY 2021
Version : A.2
Advertisement
Table of Contents
