•
Can't turn on:
•
Check Camera damage or not
•
Check camera module assembly
•
I2C interface working normally (you could verify this by LCD
backlight level adjustment or turn on VGA camera)
•
Check camera power when turn on ( R178_1.8V, R751_2.8V,
R752_2.6V )
•
Check camera reset pin (R755) signal should pull high after turn on
camera
–
AF no function:
•
Check S7 SMT
•
Check S7_pin3 signal from 2.6V to GND when you press the
capture key to the half.
•
Check camera module AF pad short with shielding case or not.
–
Capture key no function:
•
Check S7 SMT
•
Check S7_pin1 signal from 2.6V to GND when you press the
capture key.
Service Engineeing & Optimization
Level 3 , Rev.1.0
Can't Take Picture