Samsung SSG-3570CR User Manual page 2

‹ Pairing for the first time
1. Turn on the TV and wait until the TV is fully on.
2. Press the pairing button on the 3D glasses shortly. The 3D glasses will power on and
pairing will start.
3. The message "3D glasses are connected to TV." will be displayed on the TV screen when
the pairing is successfully completed.
4. Enjoy 3D video after configuring the 3D function settings on the TV.
✎ After the first pairing, putting on the 3D glasses will automatically power on the glasses.
To power off, take off the glasses.
✎ If the pairing fails, the 3D glasses will power off.
✎ If the first attempt to pair fails, turn the TV off and on again, and then go to Step 2.
✎ The LED will blink green and red alternately for 1 seconds if pairing is in progress.
‹ How to pair again: Press the pairing button on the 3D glasses for more than 1 seconds.
<Pairing is needed again in the following occasions>
– Pairing may be needed again after you have had your 3D TV repaired.
– If you want to play 3D content on another Samsung 3D TV model that belongs to the D,
E, or F series released in 2011 through 2013.
English-2
[NA]SSG-3570CR-00L17.indb 2
‹ Charging the Battery
If the red LED blinks every 2 seconds, charge the battery as shown below. The orange
LED will blink every second when battery charging is in progress. The green LED will blink
every 2 seconds when the charging is finished. (It takes about 30 minutes to fully charge
the battery that is dead; however, the time required to charge it to full capacity may vary
depending on the battery level and the voltage of the supplied power.)
USB PORT
Micro USB Cable
‹ Viewing guidelines
• When viewing 3D video under a fluorescent lamp (50Hz – 60Hz) or
3-wavelength lamp, you may notice a small amount of screen flickering.
※ If so, dim the light or turn the lamp off.
• Switching the input mode while watching a 3D movie may disable the 3D
function on the TV. As a result, the 3D glasses may not function and the
movie may not be displayed properly.
• Ensure you are within the working range when you view a 3D video.
※ If you move the 3D glasses outside of their working range, the signal from the TV
will be disconnected, and the 3D glasses will be automatically turned off. When this
happens, the red LED will turn on for 3 seconds.
SAMSUNG TV
USB1
PC
USB
Note Book
2013-01-02 9:15:09