Maintenance; General; Daily Cleaning; Replacing Display Lights - Hatco Glo-Ray GRCSCL Series Installation And Operating Manual

MAINTENANCE

General

Hatco Glo-Ray Carving Stations are designed for maximum
®
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power switch, unplug power cord, and
allow unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
• Do not steam clean or use excessive water on unit.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.

Daily Cleaning

To preserve the finish of the Glo-Ray Carving Station, it is
recommended that all surfaces be cleaned daily
NOTICE
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch the finish of the unit,
marring its appearance and making it susceptible to soil
accumulation.
IMPORTANT—DO NOT use paper towel or glass cleaner to
clean plastic surfaces. Paper towel and glass cleaner may
scratch the material. Wipe off plastic surfaces using a soft,
clean, waterdampened cloth.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Remove and wash all food pans, if necessary.
3. Clean the cutting board with mild detergent and rinse.
Apply a coating of mineral oil, allowing oil to penetrate for
a short period and wipe.
4. Wipe down all metal surfaces with a non-abrasive, damp
cloth. Stubborn stains may be removed with a non-
abrasive cleaner. Clean hard to reach areas using a small
brush and mild soap.
5. Wipe dry all surfaces using a non-abrasive, dry cloth.
6. If equipped, clean the plastic sneeze guards using soft
cleaning cloths, mild soap, and water. NOTICE: Do not
use paper towel or glass cleaner on plastic surfaces—
scratching may occur.

Replacing Display Lights

Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially coated could result in personal injury and/or
food contamination.
The display light illuminates the warming area. The display
light has a special coating to guard against injury and food
contamination in the event of breakage.
1. Turn off the unit, unplug the power cord(s), and allow the
unit to cool.
2. Unscrew the display light from the unit and replace it with
a new, specially-coated display light .
NOTE: Hatco shatter-resistant incandescent light bulbs meet
NSF standards for food holding and display areas. For
120 V applications, use Hatco P/N 02.30.265.00. For 220,
240, 220–230, and 230–240 V applications, use Hatco
P/N 02.30.266.00.
NOTE: Refer to the OPTIONS AND ACCESSORIES section for
Chef LED information.
8
English
WARNING
Form No. GRCSM-0620