Before You Start - Honeywell CT230-GA Installation Manual

Before you start

CAUTION:
• Installation must be carried out by a certified electrician and must comply with national and local
electrical codes.
• Use the CT230 linked unit for resistive load only.
• Do NOT install the CT230 linked unit in an area where it can be exposed to water or rain.
• To prevent severe shock or electrocution, always turn the power OFF at the service panel before
working with wiring.
• Install the CT230 linked unit onto an electrical box.
• Connect the wires using solderless connectors for copper wires. Use special CO/ALR solderless
connectors for connection to aluminum wires.
• Keep the top and bottom air vents (openings) of the CT230 clean and unobstructed at all times.
Read the entire document
1
CT230-GA / CT230-GB