Fm Subsystem - Fluke 9640A Series Instruction Manual

FM Subsystem

Keyword
[:SOURce]:FM
[:SOUR]:FM:STATe[?]
[:SOUR]:FM[:DEViation][?]
[:SOUR]:FM:DEViation
:OFFSet[?]
[:SOUR]:FM:DEViation:OFFS
:STATe [?]
[:SOUR]:FM:DEViation:OFFS
:APPLy [?]
[:SOUR]:FM:DEViation:OFFS
:ERRor[?]
[:SOUR]:FM:INTernal
:FREQuency[?]
[:SOUR]:FM:INT:FREQ
:OFFSet[?]
[:SOUR]:FM:INT:FREQ:OFFS
:STATe[?]
[:SOUR]:FM:INT:FREQ:OFFS
:APPLy[?]
[:SOUR]:FM:INT:FREQ:OFFS
:ERRor[?]
[:SOUR]:FM:SHAPe[?]
[:SOUR]:FM:COUPling[?]
[:SOUR]:FM:EXTernal
:TRIGger[?]
Parameter *RST
Form Condition
<bool> OFF
<NRf> 10.0 Hz
<NRf> 0.0 Hz
<bool> OFF
<bool> OFF
<NRf> 0.0 %
<NRf> 1.0 kHz
<NRf> 0.0 Hz
<bool> OFF
<bool> OFF
<NRf> 0.0 %
<name>
SINE
{SINE |
EXTernal}
<name>
AC
{AC| DC}
<name>
{DISable |
DISable
RISing |
FALLing}
SCPI Commands
SCPI Command Reference
Notes
Command long form
This command node is only available
when the FM instrument is selected.
This selects whether the output signal
has an FM component
This selects the deviation of the FM
for the FM instrument.
This value is added to the deviation of
the output value. Changes to this
value will be reflected in the
FM:OFFSet:ERRor value
This selects whether the offset mode
is present
This selects whether the offset value
is added to the output deviation.
Note: The offset state must be on for
this command to operate
Adjusts the output depth by setting the
offset as an error rather than an
absolute.
This selects the modulation frequency
of the FM
This value is added to the modulation
frequency of the output value.
Changes to this value will be reflected
in the FM:INT:FREQ:OFFSet:ERRor
value
This selects whether the offset mode
is present
This selects whether the offset value
is added to the output modulation
frequency.
Note: The offset state must be on for
this command to operate
Adjusts the output depth by setting the
offset as an error rather than an
absolute.
This selects the shape of the
modulation of the FM.
This selects the type of coupling for
the FM.
Selects the type of external trigger for
FM
4C
4C-11