Safety Features; After Sales Service - Dimplex OCR2000 Manual

being higher than the thermostat setting.
Heat Selector Switch (S)
Heat selection is provided via a rotary switch offering four
settings. The heat output can be altered to suit the application,
conditions and for improve the economy of operation.
Available output options are as follows:
Model O
OCR1500
Off
OCR2000
Off
OCR2500 Off

Safety Features

This appliance incorporates a number of safety devices. In
addition to the 'Important Safety Advice' section your attention
is drawn to the following:
Tilt Switch
The tilt switch will prevent the heater from working if it is
accidentally tipped over on its side.
If the radiator is tipped over while it is hot, disconnect the
power and allow it to cool, then stand the radiator back upright.
Reconnect the power - normal operation should be resumed.
Safety Overheat Protection
The heater is fitted with a thermal safety cut-out which will
switch off the heater should it overheat for any reason. If the
cut-out operates it is the result of abnormal overheating. The
appliance should be disconnected from the power supply and
customer services should be contacted for further advice - see

'After Sales Service'.

DO NOT attempt to reuse the product until the fault has been
suitably rectified.
Model Identifier(s):
Heat output
Nominal heat output
Minimum heat output (indicative)
Maximum continuous heat output
Auxiliary electricity Consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat output/ room temperature control
With mechanical thermostat room temperature control
Contact details
Switch setting
I II III
700W 800W 1500W
900W 1100W 2000W
1000W 1500W 2500W
Pnom
Pmin
Pmax,c
elmax
elmin
elSB
Barn Road, Dunleer, Co. Louth, Ireland, A92 WV02
Storage
If the radiator is not required for long periods, for example
during the summer, it should be stored in a dry place and
preferably covered to prevent the accumulation of dirt and
dust. The supply cord should be neatly coiled around the cable
wrap (see Fig. 1) and the plug should be inserted in to the plug
pin holes provided in the cable wrap.
Cleaning
WARNING - ALWAYS DISCONNECT THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powder or polish of
any kind on the body of the heater.
Allow the heater to cool, then wipe with a dry cloth to remove
dust and a damp cloth (not wet) to clean off stains. Be careful
not to allow moisture in to the heater.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it
should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
After Sales Service
Should you require after sales service, please contact the
retailer from whom the appliance was purchased or contact
the service number relevant to your country on the warranty
card.
Please do not return a faulty product to us in the first instance
as this may result in loss or damage and delay in providing you
with a satisfactory service.
Please retain your receipt as proof of purchase.
OCR1500 OCR2000
1.5 2.0
0.7 0.9
1.5 2.0
0.0 0.0
0.0 0.0
0.0 0.0
Additional
OCR2500
2.5
1.0
2.5
0.0
0.0
0.0
kW
kW
kW
kW
kW
kW
Yes