Acura ILX 2019 Owner's Manual page 61

Table of Contents

Advertisement

HANDLING THE UNEXPECTED
9. Models with225/40R18 92V tires: After the air pressure reaches front:
33 psi (230 kPa) rear: 32 psi (220 kPa) or more , turn off the kit.
Continue driving for another 10 minutes or until you reach the nearest
service station, whichever is sooner. Do not exceed 50 mph (80km/h).
If you have not reached a service station after 10 minutes, stop in a safe
place and check the tire pressure.
Models with P215/45R17 87V tires: Greater than 25 psi (175 kPa), but
less than front: 35 psi (240 kPa)/rear: 33psi (230 kPa), turn off the kit.
Models with 225/40R18 92V tires: Greater than 25 psi (175 kPa), but
less than front: 35 psi (240 kPa)/rear: 32psi (220 kPa), turn off the kit.
10. Unplug the power plug from the accessory power socket.
11. Unscrew the sealant/air hose from the tire valve stem. Reinstall the
valve cap.
12. Press the pressure relief button until the gauge returns to (0 kPa).
13. Apply the repair notification label to the flat surface of the wheel.
Tire sealant contains substances that are harmful and can be fatal if
swallowed. If accidentally swallowed, do not induce vomiting. Drink
plenty of water and get medical attention immediately. For skin or eye
contact, flush with cool water and get medical attention if necessary.
Running the engine with the vehicle in an enclosed or even partly
enclosed area can cause a rapid build-up of toxic carbon monoxide.
Breathing this colorless, odorless gas can cause unconsciousness and even
death. Only run the engine to power the air compressor with the vehicle
outdoors.
Getting Ready to Replace the Flat Tire
1. Open the trunk floor lid.
114 |
2. Take the tool case out. Take the
jack and wheel nut wrench out of
the tool case.
3. Unscrew the wing bolt, then remove the spacer cone. Then, remove the
spare tire.
4. Place the spare tire (wheel side up)
under the vehicle body, near the
tire that needs to be replaced.
5. Loosen each wheel nut about one
turn using the wheel nut wrench.
n
Setting Up the Jack
1. Place the jack under the jacking
point closest to the tire to be
changed.
HANDLING THE UNEXPECTED
| 115

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents