RH-17
Troubleshooting — BB
Display
faults 3
Does the display
start?
Yes
END
Page 46
No
Try changing
display module.
Does is works?
Set phone in LOCAL mode.
Use Phoenix "Message Sender"
and navegate down as follows:
DEV_HOST --> DEV_PC -->
PN_TEST -->
OBJ_ROUTING_REQ -->
OBJ_PC --> UTID -->
TEST_UI_TEST_REQ -->
TEST_DISPLAY_SET -->
NUM_SB: -->
TEST_SB_UI_DISPLAY_PATTE
RN -->SB_LENGTH. Select
"TEST_PATTERN_ALTPIXELS"
and click "Send'
Check LCD signals
LCDCSX(pin2), LCDCLK(pin5),
LCDSDA(pin4), and
LCDRESX(pin1) at H300.
Are the signal OK?
(Refer to display section)
Nokia Corporation
CCS Technical Documentation
Yes
No
No
Change UPP
Yes
Change Display
Confidential
Retest
Issue 1 04/2003