Nokia RH-6 Series Rf Description & Troubleshooting page 57

CCS Technical Documentation
The setup should now look like this:
Select
Tune Base level to –27 dBm.
Adjust DAC Values for Power Level 5 (32.5 dBm), 15 (13 dBm) and 19 (5 dBm) according
to the target values. The power levels may differ from in Phoenix mentioned target
power levels.
Make sure that the output power for Power Level 5 is equal or lower than 1dB below the
saturation output power. Determine the saturation power by setting the DAC Value to its
maximum. (For example: If the saturation output power is only 33.3dBm, then adjust the
DAC Value for Power Level 5 to 32.3dBm)
Press calculate, check if all levels match the target values, correct if necessary.
Select
Adjust DAC Values for Power Level 7, 15 and 19 according to target values.
Press calculate, check if all levels match the target values, correct if necessary.
Issue 1 10/2003
Company Confidential
TX PA Mode
TX PA Mode
Copyright © 2003 Nokia Corporation.
Company Confidential
7 - RF Description & Troubleshooting
High
Low
RH-6
Page 57